Christie J series 2.4kW Guia de preparacion descargar pdf (Pagina 38)

4-4 J Series 2.0, 2.4, and 3.0 kW Setup Guide

020-100751-01 Rev. 1 (10-2011)

Section 4: Maintenance

7. INSERT THE NEW LAMP MODULE

Align the base plate of the new lamp module under both side alignment guides (Figure 4-4) then slide the

module into the projector in the same orientation you removed the old lamp module until the resistance

increases. NOTE: A slightly harder push may be required to ensure it is fully seated. Lamp alignment marks are

provided to indicate the fully seated position.

FIGURE 4-4

8. SECURE THE INSERTION/REMOVAL LEVER

Secure the insertion/removal lever by threading the know into the threaded block by hand or using a Phillips

screwdriver. See Figure 4-5.

FIGURE 4-5

9. CLOSE THE LAMP DOOR

Using a Phillips screwdriver, secure the lamp door.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Sin comentarios

Christie J series 2.4kW Guia de preparacion Pagina 38