Christie CS70-D100U Manual de usuario descargar pdf (Pagina 10)

SOURCE SETUP

RPMS, CS50 & CS70-D100U/UF User’s Manual 2-7

If you want to use an extra video source in addition to the video source(s) connected at

INPUT 3 or INPUT 4 connect either a Composite or S-Video source to INPUT 1as shown in.

Do not connect both types here simultaneously. NOTE: For additional video inputs remove

the DVI Input module and install an optional Composite/S-Video Input Module at

INPUT 2.

Figure 2.11. Connecting Extra Video

Christie offers optional modules that allow you accommodate different signal types,

whether analog or digital. Any one of these modules can be installed in D100U

models, in the area labeled

INPUT 2. They include:

• RGB 500 Input Module (38-804606-xx)

• RGB 400 Active Loop Thru Input Module (38-804607-xx)

• RGB 400 Buffered Amplifier Input Module (38-804610-xx)

• Composite/S-Video Input Module (38-804608-xx)

• PC250 Analog Input Module (38-804609-xx)

• Serial Digital Input Module (38-804602-xx)

• Digital HDTV Input Module (38-804611-xx)

• Video Decoder Module (38-804600-01)

NOTES: 1) Connect analog HDTV signals directly to

INPUT 1 or to any “RGB” input

module installed at

INPUT 2—the optional HDTV Input Module used in earlier

Christie projector models is not needed or recommended. 2) See Appendix E,

Optional Input Modules for a brief description of each interface.

You can use one or more external Marquee



Signal Switchers or a third party

switcher in order to significantly increase the number of sources you can select. If

you are using a Marquee



Signal Switcher, connect the switcher’s RGB output to

INPUT 1 and connect an RS-232 serial communication cable between the switcher and

the projector serial port labeled

SWITCHER (see Figure 2.12). The switcher

communication link (permanently set at 9600 baud) enables you to access inputs

connected to the switcher in the same manner as those connected directly to the

projector. For most other third-party switchers, connect and access sources according

to the documentation provided with that switcher. Use high quality shielded cables.

NOTE: Make sure any Marquee



Signal Switcher connected directly to the

projector is set as “Switcher #1”. If it is not, unplug the switcher and turn the

thumbwheel to “1” before plugging back in and connecting to the projector and/or

network.

Extra Video

– COMPOSITE OR S-VIDEO

tional In

uts '

Connectin

a switcher '

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 115 116

Comentarios a estos manuales

Sin comentarios

Christie CS70-D100U Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores Christie CS70-D100U