Christie CS70-D100U Manual de usuario descargar pdf (Pagina 8)

SOURCE SETUP

RPMS, CS50 & CS70-D100U/UF User’s Manual 2-5

Figure 2.7. Connecting Composite Video Sources

Connect an S-Video input to either the 4-pin mini DIN connector or the Y and C

BNC connectors provided on the video decoder module (

INPUT 4).

NOTE: 1) Requires Optional Video Decoder module (38-804600-01). 2) Not

applicable to D100UF.

Figure 2.8. Connecting S-Video Sources

To loop a single incoming video input signal (connected at the video decoder)

through to another projector or display device, use the empty connector(s) adjacent to

this same input as described below.

Composite Video Loop Through

CONNECTIONS: From your source, connect a composite video signal to INPUT 3 using

either the small RCA plug or the adjacent BNC. Connect a second cable from

whichever

INPUT 3 connector is free to one of the composite video inputs of the next

display device or projector. Continue this looping method for each projector, using

either the phono-plug or the adjacent BNC as input into

INPUT 3, then using the other

connector as an output (i.e., loop through). Whether you use the BNC or the phono

plug as input or output depends on the type of cable you have on hand and what type

of connectors are on each end.

S-Video

Video Loo

Throu

h '

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 115 116

Sin comentarios

Christie CS70-D100U Manual de usuario Pagina 8