Christie RPMX-D132U Guia de preparacion Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
Section 1: Introduction
RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide 1-3
020-100246-02 Rev. 1 (10-2010)
FIRE HAZARD. Keep hands, clothes and all combustible material away from the
concentrated light beam of the projector. Position all cables where they cannot
contact hot surfaces or be pulled or tripped over.
All installation and maintenance procedures must be performed by a Christie
accredited service technician.
Projector must be operated in an environment that meets operating specifications, as
listed in 6 Specifications.
1.5.1 AC /Power Precautions
Use only the AC power cord supplied. Do not attempt operation if the AC supply and
cord are not within the specified voltage and power range. Refer to the license label
on the back of the projector or 6 Specifications for rated voltage and power.
The projector is equipped with a 3-wire plug with a grounding pin. This is a safety
feature. If you are unable to insert the plug into the outlet, contact an electrician to
have the outlet replaced. NEVER defeat the safety purpose of the grounding-type
plug.
Do not allow anything to rest on the power cord. Locate the power cord where
persons walking on it or objects rolling over it cannot damage the cord.
1.5.2 Lamp Precautions
Follow all safety and warning precautions regarding lamp replacement and handling.
Never attempt to access the lamp while the lamp is ON. After turning the lamp OFF, it
is crucial that you wait at least 10 minutes before handling the lamp. This provides
sufficient time for the lamp cooling fans to properly cool the lamp.
1.5.3 Labels and Markings
Observe and follow all warnings and instructions marked on the projector.
The exclamation point within the equilateral triangle alerts the user to important operating and
maintenance (servicing) instructions in the literature accompanying the projector.
The lightning flash and arrowhead symbol within the equilateral triangle alerts the user to
uninsulated “dangerous voltage” within the projector’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock.
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Comentarios a estos manuales

Sin comentarios