Christie RPMX-D132U Guia de preparacion descargar pdf (Pagina 28)

2-14 RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide

020-100246-02 Rev. 1 (10-2010)

Section 2: Installation and Setup

2.3.4 Connecting Multiple Projectors

RS-232 Network

To connect multiple projectors in a network with serial communication, connect the controlling source to the

RS-232 IN connector of the first projector in the network. Then take another serial communication cable and

connect one end to the RS-232 OUT connector and the other end to the RS-232 IN connector of the next

projector. Continue this pattern of connection with all projectors in the network. The last projector in the

network will only have a connection to the RS-232 IN connector. See

Figure 2-20.

Mixed Network

To control multiple projectors with a computer/controller having an RS-422 interface, first set them all to the

same baud rate as your RS-422 controller.

NOTE: You must enable this combination of RS-422 and RS-232 in the Communications menu. Set the

“Network Routing” option to “RS-232 and RS-422 Joined”. Refer to the user manual for details.

Then chain the projectors together by connecting an

RS-232 port of the first projector (already connected to the

computer/controller through the

RS-422 port) to an RS-232 port on the next projector in the chain. Continue

connecting projectors in this manner until you’ve reached the last projector in the chain, so that only the last

projector has one unused

RS-232 port. See Figure 2-21.

FIGURE 2-20 COMMUNICATING THROUGH RS-232

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Sin comentarios

Christie RPMX-D132U Guia de preparacion Pagina 28