Christie RPMX-D132U Guia de preparacion descargar pdf (Pagina 20)

2-6 RPMX/RPMSP-D132U & RPMSP-D180U Setup Guide

020-100246-02 Rev. 1 (10-2010)

Section 2: Installation and Setup

Lifting and transporting the projector

It is recommended that you ask for someone’s help to lift the projector and use a stable cart to transport the

projector.

Mounting

Refer to the drawings provided for your specific projector model in Appendix B Dimensions & Mounting

Information of the user manual for mounting hole locations and other technical information.

Mount the projector to a sturdy, flat surface that fits the entire projector.

Use all four mounting points to secure the projector to the surface. Refer to Appendix B Dimensions &

Mounting Information of the user manual.

Maintain an area of empty space around the projector, called a “stay out zone”, to allow for air

circulation and clearance for cable connections to the input panel. An insufficient stay out zone area can

cause the projector to overheat during operation and/or place undue stress on source connections.

Step 4 Connecting sources

All source connections are made to the input panel of the Electronics Module. Each input is labeled for easy

identification. Using the appropriate cables, connect your source. Refer to 2.2 Connecting Sources for more

details on connecting a specific source.

NOTE: An optional input module can be installed at Input 5 if additional connections are required. Refer to

Appendix D Optional Input Modules of the user manual.

Step 5 Turning the projector ON and selecting a source

A North American rated line cord is provided with this projector. For all other regions,

make sure that you are using a line cord, power plug and socket that meet the applicable rating

standards

1. Plug an approved line cord into the projector’s AC receptacle, located on the electronics module. Plug the

3-pronged end of the line cord into a grounded AC outlet.

NOTE: The outlet must be near the equipment and easily accessible. Use only the line cord provided with the

projector or a power cord of appropriate ratings that comply with regional standards.

NOTE: Do not use a line cord or AC supply not in the specified voltage and power range. Refer to

Section 6

Specifications for projector power requirements of the user manual.

2. Press for two seconds to turn the projector ON. As the projector begins initialization, an active pattern

of segments appears in the LED status display window. Commands will be ignored until “On” appears.

3. Press one of the input keys on the remote to select and display the image for the source connected in Step

RPMX-D132U

For XGA (0.69:1 lens). TD = 0.69 x W + 336 mm

RPMSP-D132U

For SXGA+ (0.69:1 lens). TD = 0.69 x W + 336 mm

For SXGA+ (1.20:1 lens). TD = 1.2 x W + 311 mm

RPMSP-D180U

For SXGA+ (0.69:1 lens). TD = 0.69 x W + 336 mm

For SXGA+ (1.20:1 lens). TD = 1.2 x W + 311 mm

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Comentarios a estos manuales

Sin comentarios

Christie RPMX-D132U Guia de preparacion Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores Christie RPMX-D132U